Vides aizsardzības princips Ultraskaņas tīrīšanas mašīna

Vides aizsardzības ultraskaņas tīrīšanas mašīnas princips:

Process flow: automatic feeding → solvent ultrasonic cleaning → solvent ultrasonic cleaning → solvent ultrasonic cleaning → drying → automatic discharge

Working principle of the ultrasonic cleaning, ultrasonic cleaning is the use of above 28 KHZ super audio signal, through the transducer introduced into cleaning fluid, converted to high-frequency mechanical vibration in the ultrasonic cleaning fluid density and radiation forward, make the liquid flow and produces tens of thousands of tiny air bubbles, the bubbles grow in ultrasonic longitudinal transmission into a negative pressure zone formation, and in positive pressure area closed quickly The formation, growth and rapid closure of these bubbles is called cavitation. In the cavitation phenomenon, the closure of these bubbles forms an instantaneous high pressure of more than 1000 atmospheres. The continuous instantaneous high pressure is like a series of small "explosions", which continuously bombards the surface of the object, making the dirt on the surface of the object and in the gap quickly peel off and achieve a rapid cleaning effect. Zero emission recycle mechanism principle: environmental ultrasonic cleaning technology is through the recycling use of cleaning solvents, achieve energy saving, high efficiency, zero line, clean environmental protection requirements, the equipment is equipped with the company patent design of solvent distillation recycling, and freeze drying device, the recycling the solvent to evaporate pavilion, condenser, oil-water separation after again into the washing tub, a virtuous circle, set For cleaning period of interior design into a closed chamber structure, front-rear pneumatic door control, transfer of mechanical arm is equipped with a special cleaning basket, cavity interior department set up efficient refrigeration system, working temperature below 0 degree , at the same time every cleaning trough installed pneumatic door seal, completely put an end to the evaporation of the solvent, ensure efficient utilization of the solvent. When the workpiece is cleaned, it enters the drying chamber. The drying chamber adopts the heat-insulating drying structure designed by the company's patent. The liquid remaining on the surface of the workpiece is dried by clean hot air to complete the whole cleaning process.